lumini_p30_control/firmware/config.h

#define VERSION_STR "2.0.0"

#define USE_STATIC_IP //! uncomment to enable Static IP Adress

#define SERIAL_BAUD_RATE 115200
                               
#define LOCAL_TIMEZONE_STRING "CET-1CEST-2,M3.5.0/02:00:00,M10.5.0/03:00:00" // Berlin, Germany - https://sites.google.com/a/usapiens.com/opnode/time-zones

//#define DEVELOPMENT

#define LIGHT_NAME "Lumini/Lominie Pixie30/P30 light control" // default light name
#define LIGHT_NAME_DEV_POSTFIX " (DEV)"

#define LIGHTS_COUNT 4 // do not modify because luminie p30 only has 4 channel, never set above 80

#define EEPROM_LAST_STATE_STARTUP_ADDRESS      0 // startup behavior is used for all lights
#define EEPROM_SCENE_ADDRESS                   1 // scene is used for all of the lights
#define EEPROM_TIMING_CONTROL_ENABLED_ADDRESS  2
#define EEPROM_DYNAMIC_IP_ADDRESS              3
#define EEPROM_LAST_STATE_ADDRESS              4 // the first "last state" information for the first light
#define EEPROM_TIMING_DATA_ADDRESS             (EEPROM_LAST_STATE_ADDRESS + LIGHTS_COUNT) // Stored data date per light ELE_USED; HH; MM; CH1; CH2; CH3; CH4; 
#define EEPROM_IP_ADDRESS                      (EEPROM_TIMING_DATA_ADDRESS + 60) // 10 blocks of 6 byte per timing control data block = 60 byte EEPROM space
#define EEPROM_GW_ADDRESS                      (EEPROM_IP_ADDRESS + 4) // step 4 byte further IP
#define EEPROM_NM_ADDRESS                      (EEPROM_GW_ADDRESS + 4) // step 4 byte further GW
#define EEPROM_DNS_ADDRESS                     (EEPROM_NM_ADDRESS + 4) // step 4 byte further NM

#define BRI_MOD_STEPS_PER_SEC                  5 // 1000ms / 40ms delay in loop / 4 functions called separately by FSM => 6.25 calls of the tc update function per second maximum => 5 step should be ok

#define TIME_CHECK_INTERVAL_MS         (60000UL) // 60 second interval
#define TIME_LIGHTENGINE_INTERVAL_MS    (1000UL / BRI_MOD_STEPS_PER_SEC) // BRI_MOD_STEPS_PER_SEC steps per second to in-/decrease the brightness

#define MY_NTP_SERVER "de.pool.ntp.org"

// 10 bit PWM
#define PWM_FREQ     (500UL)
#define PWM_OFF             0 // 0V
#define PWM_MIN             0 // 0V - minimum light amount (~1%)
#define PWM_MAX           255 // 24V - maximum light amount (100%)
#define BRI_TO_PWM_FACTOR 1.0 // 24V-0V = 24V range

#define PWM_TEST_INTERVA_MS 1000
#define TEST_PWM_CHG_CNT       1