From bdb35cbf682a4eb31ee866a0befc87dc871495da Mon Sep 17 00:00:00 2001 From: Kai Lauterbach Date: Tue, 2 May 2023 14:58:02 +0200 Subject: [PATCH] Some information added to the readme file. --- README.md | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/README.md b/README.md index ec76a98..1ecfeae 100644 --- a/README.md +++ b/README.md @@ -1,4 +1,25 @@ This build is based on: https://github.com/mariusmotea/diyHue/tree/master/Lights/Arduino/Generic_Dimmable_Light +The controller I use is a old NodeMCU v1.0, which is connected to 4x D4184 MOS breakout boards. See NodeMCU pins table beyond. +The cable I use is a https://amzn.eu/d/0jigRCh. I cut it in half and attached it to the MOS boards. +The NodeMCU‘s power supply is a 7805, it‘s output is connected to the Vin pin. +The input of the 7805 is connected to the 24V of the DC power plug. + +NodeMCU pins: + +| |ch1|ch2|ch3|ch4| +|--|--|--|--|--| +|LED color|blue|warm white|purple|white & red & green| +|Wire color|blau|schwarz|rot|weiß| +|Arduino pin names|D1|D2|D7|D5| +|GPIO|5|4|13|14| + +The HTML content is pushed to the NodeMCU separetely by using the ESP8266 Sketch Data Upload plugin of the old Arduino IDE (not "Arduino IDE"). + +After the firmware is written the first time to the NodeMCU. +The EEPROM's default values are set to default. +All except of the timing control data block. + +You have to click at the link "reset timing control data" on the webinterface.