README.md

@@ -14,13 +14,12 @@ The input of the 7805 is connected to the 24V of the DC power plug.
 
 NodeMCU pin connections to the cable wires:
 
-| |ch1|ch2|ch3|ch4||
-|--|--|--|--|--|--|
-|LED color|blue|warm white|purple|white & red & green|/|
-|Wire colors|blue (B)|black (S)|red (R)|white (W)|green (G)|
-|Color wire connection to Load PWM boards|1|2|3|4|+24V|
-|Arduino pin to PWM boards|D1|D2|D7|D5|/|
-|Arduino GPIO pin numbers|5|4|13|14|/|
+| |ch1|ch2|ch3|ch4|
+|--|--|--|--|--|
+|LED color|blue|warm white|purple|white & red & green|
+|Wire color|blue|black|red|white|
+|Arduino pin names|D1|D2|D7|D5|
+|GPIO|5|4|13|14|
 
 The HTML content is pushed to the NodeMCU separetely by using the ESP8266 Sketch Data Upload plugin of the old Arduino IDE (not "Arduino IDE").
 
@@ -43,7 +42,6 @@ The IP address is set to dynamic (DHCP) after initial flash of the NodeMCU.
 Sample schematics (no NodeMCU pins defined in there)
 
 ![Sample schematics](pic/schematics.png)
-Please note the letters "R" "G" "B" "W" "S" are also documented in the table above. These are the german shorts of the colors red green blue white black (schwarz).
 
 ![Prototype](pic/prototype.jpeg)
 

firmware/config.h

@@ -7,7 +7,7 @@
                                
 #define LOCAL_TIMEZONE_STRING "CET-1CEST-2,M3.5.0/02:00:00,M10.5.0/03:00:00" // Berlin, Germany - https://sites.google.com/a/usapiens.com/opnode/time-zones
 
-//#define DEVELOPMENT
+#define DEVELOPMENT
 
 #define LIGHT_NAME "Lumini/Lominie Pixie30/P30 light control" // default light name
 #define LIGHT_NAME_DEV_POSTFIX " (DEV)"