weatherstation/firmware/config.h

#ifndef __CONFIG_H__
#define __CONFIG_H__

#define SENSOR_TEMPERATURE    0
#define SENSOR_HUMIDITY       1
#define SENSOR_LIGHT          2
#define SENSOR_WINDSPEED      3
#define SENSOR_PRESSURE       4
#define SENSOR_BAT_VOLTAGE    5
#define SENSOR_ESAVEMODE      6
#define SENSOR_BATCHARGESTATE 7

#define BAT_CHARGE_STATE_CHARGED     2.0
#define BAT_CHARGE_STATE_CHARGING    1.0
#define BAT_CHARGE_STATE_NOTCHARGING 0.0
#define ENERGY_SAVE_MODE_ENABLED     1.0
#define ENERGY_SAVE_MODE_DISABLED    0.0

#define WIFI_AUTOCONNECT_TIMEOUT_S      120
#define WIFI_CONFIG_PORTAL_TIMEOUT_S    120
#define UPDATE_SENSOR_INTERVAL_S        300
#define UPDATE_WEBSERVER_INTVERVAL_S      1 // Do not change, bigger values will prevent using webupdater webinterface
#define DELAY_LOOP_MS                    50
#define POWERSAVING_SLEEP_S             600
#define EMERGENCY_SLEEP_S            172800 // Sleep for 2 days to recover
#define ENERGY_SAVING_ITERATIONS         30
#define WIFI_MINIMUM_SIGNAL_QUALITY      10 // percent
#define RESET_ESP_TIME_INTERVAL_MS  3600000

#define WIND_SENSOR_MEAS_TIME_S                     15.0
#define ROTOR_LENGTH_CM                             8.25
#define ROTOR_LENGTH_M          (ROTOR_LENGTH_CM / 100.0)
#define ROTOR_LENGTH_KM         (ROTOR_LENGTH_M / 1000.0)
#define SEC_TO_HOUR_FACTOR                  (60.0 * 60.0)
#define MPS_CORRECT_FACT                            9.28
#define COUNT_TO_KMH            ((TWO_PI * ROTOR_LENGTH_KM / WIND_SENSOR_MEAS_TIME_S) * SEC_TO_HOUR_FACTOR)
#define COUNT_TO_MPS             (TWO_PI * ROTOR_LENGTH_M  / WIND_SENSOR_MEAS_TIME_S)
#define WINDSPEED_FACTOR         (COUNT_TO_MPS * MPS_CORRECT_FACT)

#define HTTP_CALL_ON_WINDSPEED_EXCEED_MPS 5.0 // 5.0 m/s == 18 km/h
#define HTTP_CALL_ON_WINDSPEED_INTERVAL_S  60 // it's required to be bigger than WIND_SENSOR_MEAS_TIME_S
#define HTTP_CALL_ON_WINDSPEED_URL         "http://192.168.0.250:3001/button-windspeedexceed?event=click"

#define BAT_LOW_VOLTAGE                 3.6
#define BAT_EMERGENCY_DEEPSLEEP_VOLTAGE 3.5

#define SEALEVELPRESSURE_HPA (1013.25)

#define STATUS_LED_PIN        LED_BUILTIN
#define ANEMOMETER_PIN        D7

#ifndef BAT_PINS_D34
#define BAT_CHARGED_PIN       D6
#define BAT_CHARGING_PIN      D5
#else
#define BAT_CHARGED_PIN       D3
#define BAT_CHARGING_PIN      D4
#endif

#define BME_SCK  13
#define BME_MISO 12
#define BME_MOSI 11
#define BME_CS   10
#define BME_ADDRESS 0x76

#define INITIAL_WEBSERVER_TIME   20
#define WEB_UPDATER_HTTP_PORT  8080

#endif